User`s manual

34
3-8 Power Management Setup
The Power Management Setup allows you to configure your system to most effectively save
energy saving while operating in a manner consistent with your own style of computer use.
Whizpro BIOS SETUP Utility
Power Management : Enabled
Stand-by Timer : Off
Suspend Timer : Off
Hard Disk Power Down : Disable
Video Off : Disabled
Power Button : Delay 4 Sec.
Modem Uses IRQ : Enabled
Wake On PME : Disabled
Wake On RI : Disabled
Wake on RTC Alarm : Disabled
Alarm Date : --
Alarm Time : --:--:--
Power on After Power Loss : On
↑↓
: Select a menu
ENTER : enter a menu
ESC : quit & exit
F9 : load default CMOS settings
F10 : save settings and exit
Power Management
This item allows you to select Enabled/Disabled the Power Management, APM or ACPI. The settings are
Enabled and Disabled.
Stand-By Timer
This item allow you to set system inactive time period prior BIOS enter the system into stand-by state in
APM mode.
Suspend Timer
This item allow you to set system inactive time period prior BIOS enter the system into suspend state in
APM mode.
Hard Disk Power Down
This item allow you to set system inactive time period prior BIOS shutdown IDE drives in APM mode.
Video Off
This item allow you to set system inactive time period prior BIOS shutdown video in APM mode.
Power Button
Power Management