HIGH PERFORMANCE FURNITURE FOR YOUR HOME THEATER Alcove TM 8200 Assembly Instructions
www.bdiusa.com Alcove™ Home Theater Furniture customerservice@bdiusa.com Your Alcove™ Home Theater Furniture is engineered for easy assembly. Carefully follow this procedure to prevent any damage. BDI strongly recommends two (2) people for successful product assembly. Placement and Maintenance Alcove™ Home Theater Furniture is designed for indoor use on level floors. Clean glass with glass cleaner. Clean steel parts and wood veneer with a moist cloth. Component List Unpack and identify the parts listed.
Step 1 Remove upper panel from main cabinet structure by removing the two screws (C) from inside cabinet. Set aside until Step 2. Upper Panel Remove Cx2 I Cabinet Step 2 Install CD towers (left and right) and attach upper panel to the top of CD towers using (C x 16). CD tower *Shelves can be adjusted inside CD towers as needed.
Step 3a Install curved panel sections onto assembled structure. Engage the pre-installed draw latches to ensure panels are pulled tight, making sure there is no gap between the panels.
Step 3b Install steel plasma mounting frame using the hex wrench (I) and (A x 6). Orient steel plasma mounting frame properly so holes align with holes in curved panels.
Step 4a Secure curved panel from inside CD towers using (B - black x 2) and hex wrench (I). You will use 1 (B –black) in each CD tower. Step 4b Secure bottom of curved panel from inside of cabinet using (B - black x 2) and hex wrench (I). Screws should be completely tightened and flush or below the bottom surface. I B - black x 2 I B - black x 2 Step 4c Back panels are installed by placing them in upper groove on inside back of cabinet then lifting and dropping them into the lower groove.
Step 5 Install Flat Panel mounting brackets using (F x 8) on the front of the stand. The height position can be adjusted up and down along the length of holes as needed to accommodate your desired viewing height and your specific TV. This step is best performed with one (1) person holding the bracket in place from the FRONT of Alcove and one (1) person installing the bracket fasteners from the REAR of Alcove.
Step 6 Install Flat Panel TV using Plasma Mounting Pack. Horizontal Mounting Bar x 2 Plasma Mounting Hardware Pack Phillips Head Mounting Screws (The following thread sizes are included: M4, M5, M6, M8.) Black Washer x 8 Spacers x 8 (Large & Small) Flanged Nut x 4 Step 6a I nstall Horizontal Mounting Bars. Find the mounting screws that were supplied with your flat-screen TV.
Step 6b Install TV with attached horizontal mounting bars to flat panel mounting brackets at desired height by inserting the threaded studs into key holes. Note: Flanged nuts are provided in the Plasma Mounting Blister Pack and must be threaded on the studs of the upper mounting bar in order to prevent any damage to the TV. 2 1 Step 6c Once the threaded posts are positioned through the key holes and slots, lower TV into resting position. Tighten flanged nuts on upper mounting bar.
Fine tuning your new BDI Alcove Home Theater Furniture These steps are to be followed after you have unpacked and completed the simple assembly instructions for your Alcove stand. Due to jostling in freight or perhaps an uneven floor, the doors on your Alcove stand may not appear to be in perfect alignment (Refer to sample cabinet doors shown below). Making a few minor adjustments can rectify this situation. Be aware that depending on your situation, patience and a bit of trial and error are required.