Owner's manual

Starting the Water Pump

Use the following start instructions:

1. Make sure unit is on a flat, level surface and pump chamber is primed.

2. Turn fuel valve (1) to “On” position. The fuel valve handle will be

vertical (pointing toward the ground).

3. Push on/off switch (2) to “On” position.

4. Move engine speed lever (3) to “Fast” ( ) position.

6. Grasp recoil handle and pull slowly until slight resistance is felt. Then

pull handle rapidly to overcome compression, prevent kickback and

start engine.

5. Move choke lever (4) to “On” position.

s t a r t i n g t h e w a t e r p u m p

WARNING

Starter cord kickback (rapid retraction) can result in

bodily injury. Kickback will pull hand and arm toward

engine faster than you can let go.

Broken bones, fractures, bruises, or sprains could

result.

• When starting engine, pull cord slowly until resistance is felt and then

pull rapidly to avoid kickback.