User guide

INDUCTION SYSTEM

Do not locate the compressor where it could ingest or ignite toxic, ex-

plosive or corrosive vapors, ambient air temperatures exceeding 110 de-

grees F, water or extremely dirty air. Ingestion of any of the above noted

atmospheres by the compressor could jeopardize the performance of the

equipment and all personnel exposed to the total compressor.

Destructive pulsations can be induced by reciprocating compressors that

will damage walls and break windows. Pulsation can be minimized by

adding a pulsation dampener on the inlet side of the compressor.

pre-operation

NOISE

Noise is a potential health hazard that must be considered. There are

local and federal laws specifying maximum acceptable noise levels that

must not be exceeded. Most of the noise from a reciprocating compres-

sor originates from the air inlet point. Excessive noise can be greatly

reduced by installing an intake noise silencer.

PIPING FITUP

Care must be taken to avoid assembling the piping in a strain with the

compressor. It should line up without having to spring or twist into posi-

tion. Adequate expansion loops or bends should be installed to prevent

undue stresses at the compressor resulting from the changes between

hot and cold conditions. Pipe support should be mounted independently

of the compressor and anchored as necessary to limit vibration

and prevent expansion strains.

SAFETY VALVES

Safety valves are pressure relief valves and should be sized and pur-

chased with a pressure setting to protect the weakest link in the system.

Never change the pressure setting, only the safety valve manufacturer is

qualified to make a change.

Safety valves are to be place ahead of any potential blockage point which

included but is not limited to, shutoff valves, heat exchangers, pulsation

dampeners, and discharge silencers.

WARNING

Under no circumstances should a compressor be placed in an area that

may be exposed to a toxic, volatile or corrosive atmosphere nor should

toxic, volatile or corrosive agents be stored near the compressor.