Installation & Assembly

page 6
6. Wiring.
wall control
wall control
back plate
back plate
screw
back plate screw
safety cable
wood screw
and washer
hanging bar
wood joist
black
white
black
green/ground
bare/ground
from fan
white
*
black
black
AC IN
black
AC IN
black
AC TO FAN
black
AC TO FAN
black
*
wall control
wire
from
ceiling
CAUTION: Be sure outlet box is properly
grounded and that a ground wire (GREEN or
Bare) is present.
Make sure all electrical connections comply
with Local Codes or Ordinances and the
National Electrical Code. If you are unfamiliar
with electrical wiring or if the wires in the
house/building are different colors than those
mentioned below, please consult with a
qualified electrician.
Connect BLACK wire from fan to BLACK
wire from ceiling. Connect WHITE wire from
fan to WHITE wire from ceiling. Connect
GREEN wire from fan to BARE/GREEN wire
from ceiling. Use wire connectors provided
when making connections.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
Turn spliced/taped wires upward and gently
push these wires and wire connectors into
outlet box.
7. Wiring - Wall Control
Remove existing wall switch. Remove wall
control back plate by removing 2 screws on
the wall control--one on the top and one on
the bottom. Secure wall control back plate
to wall or structure with screws from
existing wall switch.
Connect BLACK wire from wall control to
BLACK (AC TO FAN) wire from wall.
Connect BLACK wire from wall control to
BLACK (AC IN) wire from wall. Use wire
connectors provided when making
connections.
* Wrap each wir
e connector separat
ely with
electrical tape as an extra safety measure.
T
urn spliced/taped wires upward
and gently
push these wir
es and wire connect
ors into
back plate.
Re-attach wall control to back plate using
the 2 screws that were previously removed.
wall
fan/
motor housing