Replacement Part List

26FB
TURF BEAST
Rev: July 2015
TURF BEAST Finish Mower
9
Assembly Instructions
Step 2: Mower Assembly Instructions
A. Attach handle bars using the upper hole
position setting. Using this hole position
sets the handle bars several inches lower.
Use the lower hole position raising the
handle bar location by several inches for
comfort, if necessary. These hole positions
can also be used for adjusting the handle
bar location for operators of different
heights and arm lengths. Select the height
that is most comfortable for you.
B. Reconnect the four (4) connecting rods
from the control panel to the chassis pivot
points as shown in the picture to the right.
The rod connections are secured with an
initial preset for the upper hole position
(lower handle bar position). If the lower
hole position (upper handle bar position) is
used, the rod connections must be
adjusted.
C. Should the pivot ends on the connecting
rods be rotated during assembly, minor
adjustments may be required to achieve
full travel on each control handle. The
control handles located directly on top
of the handle bars should have full
travel forward and stop approximately
1/8-inch before the V-plate strikes the
handle bar. This positioning provides
full forward speed and the correct
restricted speed in reverse. Make minor
adjustments to the position of the threaded
connecting rod attachment to achieve this
control positioning.
1/8” gap in
full forward position
V-plates