Replacement Part List

26FB
TURF BEAST
Rev: July 2015
TURF BEAST Finish Mower
10
Assembly Instructions
Step 3: Wire Harness Assembly and
Connections
The pre-wired handle bar assembly has a total of
four (4) connections. Route the wire harness as
shown in the top right photo and make the
following connections indentified by number in
the other photos:
1. Route the smaller, white, 2-pin connector
through a hole in the chassis and connect it
to the blade activation safety switch 2-pin
connector.
2. Connect the larger, 5-pin connector to the
mating connector at the rear of the engine.
3. Connect the black wire to a ground lug
located on the back or side of the engine.
4. If equipped, attach the yellow wire to the
bottom of the starter motor solenoid on the
engine, with the positive (red) battery cable.
Attach the positive (red) and ground (black)
battery terminal wires to the battery to provide
power to the electric starter.
Note: Battery ground should be to the engine
block.
Once all connections are made, use the
provided black wire-ties to strap the wire harness
into place permanently to the handle bars and
chassis.
Step 4: Throttle and Choke Cable
Connections
The throttle and choke are shown in the adjacent
photo. See instructions for connecting them to
the engine in the Engine Owner’s Manual
provided.
Throttl
Chok