Replacement Part List

26FB
TURF BEAST
Rev: July 2015
TURF BEAST Finish Mower
17
General Maintenance
The Importance of Maintenance
Regular maintenance is essential to ensure your
mower continues to deliver safe and high-quality
performance.
To help you properly care for your mower, the
following pages include a recommended
maintenance schedule, routine inspection
procedures, and simple maintenance procedures
using basic hand tools. Maintenance is the
responsibility of the owner and must be performed
regularly. More difficult service tasks or tasks that
require special tools are best handled by a
recommended service technician or other
qualified mechanic.
The maintenance schedule described on page 15
applies to mowers used under normal operating
conditions. If you operate your mower under
severe conditions, such as sustained prolonged
use or high-temperature operations, or use it in
unusually wet, dusty or rocky conditions, consult
your servicing dealer for recommendations
applicable to your individual needs and use.
Be sure to use genuine TURF BEAST mower
replacement parts when servicing your mower to
assure the best quality, safety and performance.
Need Help? Parts, Service and Technical
Assistance Call: 1-919-550-3221
www.brushbeast.com
CAUTION! Before
making any adjustments and/or servicing to your
TURF BEAST mower, make sure the mower is on
a flat and level surface, with the ignition switch off,
the key removed, and the blades disengaged.
Also, disconnect the spark plug wires from the
spark plugs and ground them against the engine
to prevent inadvertent starting.
If you are performing adjustments or maintenance
after operating the mower, allow the unit to cool
since heat build up could cause severe burns.
Tire Pressure
Incorrect tire pressure may cause the mower to
pull to one side and/or result in uneven cut. Use
caution when filling the tires. NEVER exceed the
recommended maximum tire pressure.
Air Filter
Refer to the Engine Owner’s Manual for the
recommended maintenance.
Fuel
DANGER: Gasoline is highly flammable and
explosive. Do not add fuel while the engine is
running or is hot. Keep open flames, sparks,
and heat away from the fuel and store fuel in
containers specifically designed for that
purpose. Add fuel outdoors only and if the fuel
is spilled, do not start the engine. Manually
push the mower away from the spill and wipe
up immediately.
A fuel shut off valve is located XXXXXX. It is
recommended that the fuel be shut off when
transporting between job sites and when storing
the mower for extended periods of time.
CAUTION
DANGER
CAUTION: Always wear work gloves when
performing blade maintenance and beware of
the cutting edges. Be sure the engine is off,
the key removed, and the spark plug wires are
disconnected from the spark plugs to prevent
inadvertent starting.
CAUTION
Blades
Inspect blades on a daily basis for nicks, bends,
and excessive wear. If the blades are worn,
cracked, bent, or damaged, replace them before
using the mower. Choose genuine TURF BEAST
mower replacement blades to ensure quality and
performance. (See page XX for blade removal
instructions.)
When sharpening the blades, sharpen only the
cutting edges and try to maintain the original angle
of the blade. Do not make the cutting edge razor
sharp. Remove the same amount from each side
of the blade so that balance in maintained.
Engine Oil
CHECK ENGINE OIL BEFORE EACH USE. Refer
to the Engine Owner’s Manual for the type of oil to
use, oil change intervals, and the proper
procedures to check and change oil.
Insert illustration
of fuel shut off
valve