Instructions / Assembly

pair remote

The original remote that comes in the box is already paired to the bed base. No further action is required.

In the event that the remote is not paired with the base, follow the steps below.

If the Power Down Box is not available :

• Remove back cover of the remote, locate the rubber button in the center of the back.

• On the control box located underneath the bed, double click the RESET button, light will illuminate.

• Press and hold the back rubber button on the remote. The button will begin to ﬂash then become a

continuous solid light for 1 to 2 seconds and then turn o.

• Once the remote is paired, replace back cover of the remote and test base functionality.

Remove back cover from remote

control. Remove and replace

batteries.

Press and hold button on the back

of the remote. The light will begin

to ﬂash then become a continuous

solid light.

Both lights on the Power Down Box

and the Remote will be continuous,

then simultaneously turn o.

Replace back cover of the remote.

The remote is now paired with the

base.

Double click the button on the

Power Down Box (this will not

cause the base to move). The

light will illuminate.

STEP