Use and Care Manual

To setup Sleeptracker® sensors, see page 16.

installation guide

Ensure batteries are correctly installed in the back of

the remote.

Quickly test functions to verify proper setup before

placing mattress on base. Press FLAT to return the

base to a ﬂat position.

Uncoil the Power Cord and connect to the Power Supply.

Place Power Supply on the ground and extend from

the base.

Ensure that the Power

Supply and all attached

cords are directed

toward the desired

surge protector.

Carefully ﬂip the base over on to its legs.

Important: Two people are required to move the bed

base. Do not drag across the ﬂoor. Do not rest frame

on its side, excessive pressure may damage the legs.

Plug the base into a power source. A surge protector is

strongly recommended.

STEP

Always use two people when setting up the base

STEP

Basic setup is now complete!

Place the mattress on the

base.

Select Beautyrest® mattresses*

are compatible with the

mattress retainer attachment

panel installed on the

SmartMotion™ bases

*If the mattress is not

compatible with the

attachment panel, a

mattress retainer bar is

available for purchase at:

1-888-550-3746

WARNING

Always unplug the base from the electrical outlet before servicing any

part of the base. To reduce risk of electric shock, unplug the base before

cleaning. To safely disconnect, ensure the base is in a ﬂat position with all

motors o, and unplug from power source.