Installation Guide

With the bases in their desired location, slightly loosen both

legs to allow the strap to ﬁt on the leg bolt, between the leg

washer and frame.

Slide side (a) of the connecting strap onto leg bolt. Swing the

strap and connect side (b) to the leg bolt. Secure the strap by

shifting to the left.

Re-tighten legs. Do not over tighten. Use the remaining

strap and repeat on other end of the base.

STEP 2

STEP 1

STEP 3

connecting straps (optional)

If any split setup is being installed, plastic connecting straps are provided (one per base) to secure the bases

together. Use both straps to secure the head and foot portions together.