User Manual

8

Use the rotary switch to select the type of test you want to perform.
42 44
43
 
42
L (Line)
43 PE (Protective Earth)
44 N (Neutral)

The Model Telaris ProInstall-100 and Telaris ProInstall-200 have an IR (infrared) port, see
Figure 23, which allows you to connect the tester to a computer and upload test data using
a Amprobe PC software. This automates your troubleshooting or recording process, reduces
the possibility of manual error and allows you to collect, organize, and display test data in
a format that meets your needs. See “Uploading Test Results” on page 40 for additional
information on using the IR port.

Various error conditions are detected by the tester and are indicated with the W icon,
“Err”, and an error number on the primary display. See table below. These error conditions
disable testing and, if necessary, stop a running test.
Figure 6. Error Display
  
Self-test Fails 1 Return the tester to a Amprobe Service Center.