User Manual
22
1. Connect the IR serial cable to the serial port on the PC.
2. Attach the IR adapter and the device to the tester as shown in Figure 23.
3. Start the Amprobe PC software program.
4. Press
to turn on the tester.
5. Refer to the software documentation for complete instructions on how to upload data
from the tester.
Periodically wipe the case with a damp cloth and mild detergent. Do not use abrasives or
solvents.
Dirt or moisture in the terminals can affect readings.
1. Turn the meter off and remove all test leads.
2. Shake out any dirt that may be in the terminals.
3. Soak a new swab with alcohol. Work the swab around each terminal.
Battery voltage is continuously monitored by the tester. If the voltage falls below 6.0 V (1.0
V/cell), the low battery icon
appears on the display, indicating that there is minimal
battery life left. The low battery icon continues to appear on the display until you replace
the batteries.
WWarning
Replace the batteries with six AA batteries. Alkaline batteries are supplied with the tester
but you can also use 1.2 V NiCd or NiMH batteries. You can also check the battery charge so
that you can replace them before they discharge.
WWarning
1. Press
to turn the tester off.
2. Remove the test leads from the terminals.
3. Remove the battery door by using a standard-blade screwdriver to turn the battery door
screws (3) one-quarter turn counterclockwise.
4. Press the release latch and slide the battery holder out of the tester.