User Manual

5


Use the rotary switch (Figure 1 and Table 4) to select the type of test you want to perform.

Use the rotary switch to select the type of test you want to perform.Use the pushbuttons to
control operation of the tester, select test results for viewing, and scroll through selected
test results.
RCD
NO TRIP
15
16
1819
20
17
12
13 14
11
7
4
3
5
2
1
6
8
9
10
 
1
Starts the selected test. The TEST key is surrounded by a “touch pad”. The touch
pad measures the potential between the operator and the tester’s PE terminal.
If you exceed a 100 V threshold, the
W symbol above the touch pad is illuminated.
2
•Scrollmemorylocations.
•Setmemorylocationcodes.
3 Above the touch pad is illuminated.
4
•EntersMemorymode.
•Activatesmemorysoftkeyselections(F1,F2,F3,orF4).
5 Turns the backlight on and off.
6
Turns the tester on and off. The tester will also shut off automatically is there is
no activity for 10 minutes.

•Loopinputselect(L-N,L-PE).
•Voltageinputselect(L-N,L-PE,N-PE).
•RCDcurrentrating(10,30,100,300,500,1000mA
•MemorySELECT.
8
•RCDCurrentmultiplier(x1/2,x1,x5)
•MemorySTORE.
9
•SelectRCD:TypeAC(sinusoidal),TypeACSelective,TypeA(half-wave),TypeA
Selective, Type B (smooth DC), or Type B Selective.
•MemoryRECALL.
10
•RCDtestpolarity(0,180degrees).
•Insulationtestvoltage(100,250,500,or1000V).
•MemoryCLEAR.