TDS

TECHNICAL DATA SHEETTECHNICAL DATA SHEET
INTERIOR/EXTERIOR DIRECTTOMETAL SEMIGLOSS PAINT
NO. 3200 WHITE
CAUTIONS/LIMITATIONS:
Protect from freezing.
Do not use on oors.
For best results, apply when air, material and surface
temperatures are between 50°F and 90°F, the relative
humidity is no greater than 85%, and surface is at least
5°F above dew point. Do not apply in direct sunlight.
Temperatures above 90°F can cause the paint to dry too
fast, whereas temperatures below 50°F can inhibit proper
lm formation.
Allow 4 weeks before washing or cleaning for full cure.
High tint load colors, such as safety and deep base colors,
may impact nal lm properties. A primer such as BEHR
Interior/Exterior Metal Primer No. 435 is recommended for
best results.
Not for direct application to surfaces nished with baked-
on enamels and powder coatings.
Certain colors may require additional coats for complete
hide.
Shelf life under normal conditions is 2 years unopened.
GENERAL INFORMATION:
CAUTION IRRITANT. CAUSES EYE AND SKIN IRRITATION.
MAY CAUSE RESPIRATORY TRACT IRRITATION. MAY CONTAIN:
CRYSTALLINE SILICA AND CARBON BLACK. Avoid contact
with skin and eyes. Do not breathe dusts, vapor, or spray
mist. Sanding, grinding or abrading may release sanding
dust, which may be harmful if inhaled and has been shown
to cause lung damage or cancer with long term exposure.
To avoid breathing in dust, vapors, and spray mist, open
windows and doors or use other means to ensure fresh air
entry during application, drying, sanding, and/or abrading.
If properly used, a respirator (NIOSH approved with
particulate pre-lter) may oer additional protection and
should be used if adequate ventilation cannot be provided;
obtain professional advice before using. If you experience
eye watering, headaches, or dizziness during application or
drying, increase fresh air or leave the area. Wash thoroughly
after handling. Close container after each use.
FIRST AID: If you experience diculty in breathing,
leave the area to obtain fresh air. If continued diculty is
experienced, get medical assistance immediately. In case of
eye contact, ush immediately with plenty of water for at
least 20 minutes and get medical attention; for skin, wash
thoroughly with soap and water. If swallowed, get medical
attention immediately.
KEEP OUT OF REACH OF CHILDREN – DO NOT TAKE
INTERNALLY.
This information is provided “as is” and no representations or warranties, either express or implied, of merchantability, tness for a particular purpose or of any other
nature are made with respect to this information or to any product referred to in this information. For SDS or to consult with a Behr Paint Company representative, call
1-800-854-0133 Ext. 2 (U.S.A. only). ©2023 Behr Process Corporation, Santa Ana, CA 92705 U.S.A.
Revised 4/2023
3 of 3