TDS
TECHNICAL DATA SHEETTECHNICAL DATA SHEET
This information is provided “as is” and no representations or warranties, either express or implied, of merchantability, tness for a particular purpose or of any other nature are
made with respect to this information or to any product referred to in this information. For SDS or to consult with a Behr Paint Company representative, call 1-800-854-0133 Ext. 2
(U.S.A. only) or visit behr.com. ©2019 Behr Process Corporation, Santa Ana, CA 92705 U.S.A.
Revised 12/2019
2 of 2
SYSTEM RECOMMENDATIONS:
Wood:
• 1 coat BEHR® Multi-Surface Interior/Exterior
Stain-Blocking Primer & Sealer No. 436
2 coats BEHR PRO® e600 Exterior Paint
Masonry: Concrete, Cement, Brick, Stucco, EIFS
• 1 coat BEHR Multi-Surface Interior/Exterior Stain-Blocking
Primer & Sealer No. 436 (recommended for masonry with
pH level up to 13)
2 coats BEHR PRO e600 Exterior Paint
Concrete Masonry Units: Concrete Block, Cinder
Block, Split-Face Block
• 1 coat BEHR DRYPLUS® Masonry Waterproofer No. 875
2 coats BEHR PRO e600 Exterior Paint
Fiber-Cement
• 1 coat BEHR Multi-Surface Interior/Exterior Stain-Blocking
Primer & Sealer No. 436
2 coats BEHR PRO e600 Exterior Paint
Ferrous and Non-Ferrous Metals:
• 1 coat BEHR Interior/Exterior Metal Primer No. 435
(recommended for optimal corrosion resistance or when
priming over sound rusty metal surfaces) or BEHR
Multi-Surface Interior/Exterior Stain-Blocking Primer
& Sealer No. 436
2 coats BEHR PRO e600 Exterior Paint
Vinyl, PVC, Fiberglass, Architectural Plastics
• 1 coat BEHR Interior/Exterior Bonding Primer No. 432 or
BEHR Multi-Surface Interior/Exterior Stain-Blocking Primer
& Sealer No. 436
2 coats BEHR PRO e600 Exterior Paint
NOTE: Certain substrate and exposure conditions, as
well as project requirements, may necessitate the use
of other substrate-specic or solution-driven primers.
Please consult with a BEHR PRO® Rep for specic primer
recommendations.
CLEANUP/DISPOSAL:
Clean all tools and equipment with warm, soapy water.
Do not dispose of this product down a drain. If spilled,
contain material and remove with an inert absorbent.
Dispose of contaminated absorbent, container and unused
product in accordance with all current federal, state
and local regulations. For recycling or disposal of empty
containers, unused product and soiled rags, contact your
household refuse collection service.
CAUTIONS/LIMITATIONS:
• Protect from freezing.
• Do not use on oors.
• For best results, apply when air, material and surface
temperatures are between 35°F and 90°F. When the air
temperature is at 35°F, substrates may be colder; prior to
painting, check to be sure the air, surface, and material
temperatures are above 35°F and at least 5°F above the
dew point. Avoid using if rain or snow is expected within
2-3 hours. Do not apply at air or surface temperatures
below 35°F or when air or surface temperatures may
drop below 35°F within 48 hours. Do not apply in direct
sunlight. Temperatures above 90°F can cause the paint to
dry too fast.
• Allow 2 weeks for full cure before washing or cleaning.
• Shelf life under normal conditions is 2 years unopened.
GENERAL INFORMATION:
CAUTION IRRITANT MAY CAUSE EYE, NOSE AND THROAT
IRRITATION. AVOID CONTACT WITH SKIN AND EYES AND
AVOID BREATHING OF VAPORS AND SPRAY MIST. WEAR EYE
PROTECTION AND PROTECTIVE CLOTHING. USE ONLY WITH
ADEQUATE VENTILATION. To avoid breathing vapors and
spray mist, open windows and doors or use other means
to ensure fresh air entry during application and drying.
If you experience eye watering, headaches or dizziness,
increase fresh air. If properly used, a respirator (NIOSH
approved for organic vapor with P series particulate
pre-lter) may oer additional protection; obtain
professional advice before using. A dust mask does not
provide protection against vapors. Avoid contact with eyes
and skin. Wash thoroughly after handling. Close container
after each use.
FIRST AID: If you experience diculty in breathing,
leave the area to obtain fresh air. If continued diculty is
experienced, get medical assistance immediately. In case
of eye contact, ush immediately with plenty of water for
at least 20 minutes and get medical attention; for skin,
wash thoroughly with soap and water. If swallowed, get
medical attention immediately.
CAUTION: KEEP OUT OF REACH OF CHILDREN – DO NOT
TAKE INTERNALLY.
e600 EXTERIOR FLAT PAINT
NO. PR610 WHITE BASE