SDS

Treat symptomatically.
Indication of immediate
medical attention and special
treatment needed
Ensure that medical personnel are aware of the material(s) involved, and take precautions to
protect themselves.
General information
5. Fire-fighting measures
Water fog. Foam. Dry chemical powder. Carbon dioxide (CO2).
Suitable extinguishing media
Do not use water jet as an extinguisher, as this will spread the fire.
Unsuitable extinguishing
media
During fire, gases hazardous to health may be formed.
Specific hazards arising from
the chemical
Self-contained breathing apparatus and full protective clothing must be worn in case of fire.
Special protective equipment
and precautions for firefighters
Move containers from fire area if you can do so without risk.
Fire fighting
equipment/instructions
Use standard firefighting procedures and consider the hazards of other involved materials.
Specific methods
No unusual fire or explosion hazards noted.
General fire hazards
6. Accidental release measures
Keep unnecessary personnel away. For personal protection, see section 8 of the SDS.
Personal precautions,
protective equipment and
emergency procedures
Large Spills: Stop the flow of material, if this is without risk. Dike the spilled material, where this is
possible. Absorb in vermiculite, dry sand or earth and place into containers. Following product
recovery, flush area with water.
Small Spills: Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to
remove residual contamination.
Never return spills to original containers for re-use. For waste disposal, see section 13 of the SDS.
Methods and materials for
containment and cleaning up
Avoid discharge into drains, water courses or onto the ground.
Environmental precautions
7. Handling and storage
Avoid prolonged exposure. Observe good industrial hygiene practices.
Precautions for safe handling
Store in tightly closed container. Store away from incompatible materials (see Section 10 of the
SDS).
Conditions for safe storage,
including any incompatibilities
8. Exposure controls/personal protection
Occupational exposure limits
US. OSHA Table Z-1 Limits for Air Contaminants (29 CFR 1910.1000)
Form
ValueComponents Type
PEL 15 mg/m3 Total dust.Titanium dioxide (CAS
13463-67-7)
US. OSHA Table Z-3 (29 CFR 1910.1000)
Form
ValueComponents Type
TWA 0.8 mg/m3Amorphous silica (CAS
112926-00-8)
20 mppcf
TWA 5 mg/m3 Respirable fraction.Titanium dioxide (CAS
13463-67-7)
15 mg/m3 Total dust.
50 mppcf Total dust.
15 mppcf Respirable fraction.
US. ACGIH Threshold Limit Values
ValueComponents Type
TWA 10 mg/m3Titanium dioxide (CAS
13463-67-7)
BEHR ULTRA Scuff Defense Interior Flat - Ultra Pure White SDS US
949297 Version #: 01 Revision date: - Issue date: 13-June-2019
2 / 6