Version 1.1 January 2001 EURORACK ® www.behringer.
EURORACK MX802A FOREWORD Dear Customer, Welcome to the team of EURORACK users and thank you very much for expressing your confidence in BEHRINGER products by purchasing this unit.
EURORACK MX802A TABLE OF CONTENTS 1. INTRODUCTION..................................................................................................................... 6 1.1 Architecture .................................................................................................................................... 1.2 Before you begin ............................................................................................................................. 1.2.1 PSU (power supply unit) ...............
EURORACK MX802A 1.2.2 Warranty Please take the time to fill out and return the warranty card within 14 days from the date of purchase, so as to be entitled to benefit from our extended warranty. Or use our online registration option available on the Internet at www.behringer.com. 1.2.3 Packing Your BEHRINGER MX802A was carefully packed in the factory and the packaging was designed to protect the unit from rough handling.
EURORACK MX802A 4.2 Stereo aux returns There are two additional stereo line inputs (aux returns 1 and 2) on your MX802A. Their level can be adjusted with and . Aux returns 1 is permanently assigned to the main mix. If you connect a jack only to the left socket, the aux return 1 operates in mono. Aux return 2 can be switched between the main mix and the cue feed (aux send 1) via a switch marked FX TO AUX 1 . This enables you to provide a wet cue mix (signal with effect i.e.
EURORACK MX802A 5.4 Auditioning a signal and setting up a channel 1) Where applicable, engage the low cut switch frequency content. 2) Turn up channel volume to unity gain ( counter-clockwise (minus infinity). for most mics, except for signals with desired very low to 0). All other channel volume controls should be set fully 3) Generate a signal, i.e. a voice through a microphone. There should now be some activity at the bargraph meters .
EURORACK MX802A Phantom power (+48 V DC) is provided. This can be switched on or off by the +48 V phantom switch + . Care should be taken NOT to plug mics into the console (or stagebox) while the phantom power is on. Also, mute the monitor/PA speakers when turning phantom power on or off. Allow the system to adjust for a couple of seconds after engaging phantom power before setting input gains.
EURORACK MX802A 15
EURORACK MX802A 8. WARRANTY § 1 WARRANTY CARD/ONLINE REGISTRATION To be protected by the extended warranty, the buyer must complete and return the enclosed warranty card within 14 days of the date of purchase to BEHRINGER Spezielle Studiotechnik GmbH, in accordance with the conditions stipulated in § 3. Failure to return the card in due time (date as per postmark) will void any extended warranty claims.