Instruction Manual

Hardware Replacement
6.5 ReplacingtheBacklight
Note:
Alllampsinthedisplaymustbereplacedatthesametime.
The following is needed:
• A ne w backlight, see Available Spare P arts for EPC T A100 AM
• AtorxT10screwdriver
Note:
MakesuretouseadequateESDprotection.
Follow the steps below to replace the battery of the EPC TA100 AM:
1.
First, follow the steps 1–5 in section Replacing the Rear Cover.
2.
Gently move the backlight diagonall y in direction from the display center to
release the snap-in closure that keeps the backlight in place.
3.
Remove the backlight from the display.
backlight snap lock
backlight
connectors
4.
Insert the new backlight. Be careful not to pull the cables of the new backlight
when inserting it, since pulling the cables will damage the backlight.
5.
Re-assemble the complete P anel PC.
BeijerElectronics, MAEN043
23