Instruction Manual
Safety Precautions
1SafetyPrecautions
Both the installer and the owner and/or o perator of the Panel PC must read and
understand this installation manual.
1.1 General
• Read the safety precautions carefully.
• Check the delivery for transportation damage. If damage is found, notify the
supplier as soon as possible.
• Do not use the Panel PC in an environment with high explosive hazards.
• The supplier is not responsible for modified, altered or reconstructed
equipment.
• Use only parts and accessories manufactured according to specifications of
the supplier.
• Read the installation and operating instructions carefully before installing,
using or repairing the Panel PC.
• Neverallowfluids,metalfilingsorwiringdebristoenteranyopeningsinthe
Panel PC. This may cause fire or electrical shock.
• Only qualified personnel may operate the Panel PC.
• Storing the Panel PC where the temperature is lower/higher than
recommended in this manual can cause the LCD display liquid t o
congeal/become isotopic.
• The LCD d isplay liquid contains a powerful irritant. In case of skin contact,
wash immediately with plenty of water. In case of eye contact, hold the eye
open,flushwithplentyofwaterandgetmedicalattention.
• Thefiguresinthismanualservesanillustrativepurpose. Becauseofthemany
variables associated with any particular installation, t he supplier cannot
assume responsibi lity for actual use based on the figures.
• The supplier neither guarantees that the Panel PC is suitable for your
particular application, nor assumes responsibility for your product design,
installation or operation.
1.2 DuringInstallation
• The Panel PC is designed for stationary installation on a plane surface, where
the following conditions are fulfilled:
– no high explosive risks
– no strong magnetic fields
– no direct sunlight
– no large, sudden temperature changes
• Install the product according to the accompanying installation instructions.
• Ground the product according to the accompanying in stallation instructions.
• Only qualified personnel may install the Panel PC.
• Separate the high voltage, signal and supply cables.
• Make sure that the voltage and polarity of the power source is correct before
connecting the product to the power outlet.
• Peripheral equipment must be appropriate for the application and location.
BeijerElectronics, MAEN043
5