Owner's manual
Safety Precautions
• For Canada also AVERTISSEME NT – AVANT DE DECONNECTER
L’EQUIPEMENT, COUPER LE COURANT OUS’ASSURER QUE
L‘EMPLACEMENT EST DESIGNE NON DANGEREUX.
Warning:
OnlyULandcULapprovedexpansionunitsareallowedt obeconnectedto
theportdesignated“EXPANSION”. Atthemomenttherearenosuchunits
evaluatedorallowed.
Warning:
Donotreplaceexpansionunitunlesspowerhasbeenswitchedofforthearea
isknowntobenon-hazardous.
• This product contains a battery; this must only be changed in an area known
to be non-hazardous.
• Replace the battery with a BR 2032 battery. Use of another type of battery
may present a risk of fire or explosion.
Warning:
Batterymay explodeifmistreated. Donotrecharge,d
isassembleordispose
ofinfire.
• For use on a flat surface of a type 4X enclosure indoor use only.
• Use 75 degree conductors only
• Use copper conductors only
• To make wiring connections to the power supply connector, follow the table
with cable and torque specifications below:
TerminalBlockNo. WireSizeAWG TQLb.In.
X1/X100Phoenixconnectors AWG30–12 5–7
X1/X100Anytekconnectors AWG24–12 3.5
• ThesedevicesareClass2suppliedprogrammablecontrollers(industrialPCs)
for the use in indus trial control equipment and are intended to be ( front)
panel mounted (Type 1 and 4x for indoor use only).
1.3 DuringInstallation
• The operator panel is designed for stationary installation on a plane surface,
where the following conditions are fulfilled:
– no high explosive risks
– no strong magnetic fields
– no direct sunlight
– no large, sudden temperature changes
• Install the product according to the accompanying instal lation instructions.
• Ground the product according to the accompanying installation instru ctions.
• Only qualified personnel may install the operator panel.
BeijerElectronics, MAEN096C
5