Owner's manual

Installation
2.2 InstallationProcess
The following is needed:
• ATorxTX7screwdriver
1.
Unpack and check the delivery. If damage is found, notify the supplier.
Note:
Placetheoperatorpanelonastablesurfaceduringinstallation.
Droppingthepanelorlettingitfallmaycausedamage.
2.
Usethecutoutdimensionsthatareincludedontheoutlinedrawing,found
in section Operator Panel Drawings and in the Technical Data table, to cut
a correct opening in the cabinet. A separate cut out drawing is available for
download from the Beijer Electronics web site.
3.
Secure the operator panel in position by screwing the M4 Torx s crew, allowing
the built-in bracket to tighten against the panel:
M4 x 20.7
0.4 Nm
BeijerElectronics, MAEN096C
8