Operation Manual

- C 41 -

Short Seam Automat 2211-5 Working Instructions Beisler Automated Sewing Equipment

C.3

Start-up

C.3.1 Machine table alignment

After the machine has been installed at the desired loca-

tion, the machine table must be aligned:

• Set machine table to required height.

• Align machine table horizontally on all sides.

Setting table height:

1. Fig. 1: Lift machine: Connect lifting device at lift points

(arrows) below the crossmembers. If the machine is

equipped with optional transport rollers, release bra-

kes before lifting.

2. Fig. 2: Loosen lockscrews

on all guide rails.

3. Pull table legs

out to the desired length and retigh-

ten lockscrews

4. Lower machine to floor.

Horizontal positioning of the machine table:

1. Place bubble level onto working plate.

2. Fig. 2: Loosen table leg lock nuts

3. Align machine table horizontally on all sides by raising

or lowering table legs as required.

4. Retighten table leg lock nuts.

NOTE - Shipping braces!

Before the machine is connected to the power sup-

ply system, all shipping braces must be removed.

• Cut off cable ties.

• Remove labels.

Fig. 1/2

Fig. 1

Fig. 2