Operation Manual

- C 48 -
Short Seam Automat 2211-5 Working InstructionsBeisler Automated Sewing Equipment
C.5
Maintenance
C.5.4 Repairs
Clamp transport belt replacement:
1. Disconnect machine from power supply system.
2. Slide clamp to left until it reaches stop position.
3. Fig. 7: Remove retaining screws
3
from drive roller
cover
2
and remove cover.
4. Remove two retaining screws from slide roller cover
8
and remove cover
9
.
5. Loosen two belt lock screws
4
and release belt ten-
sion
7
.
6. Loosen lock nuts
6
of set screws
5
and rotate two
set screws backward.
7. Fig. 8: Remove two connecting screws
1
from main
clamp pedestal. Remove belt.
8. Fig. 7: Install new belt to drive roller
1
and to guide
roller
a
.
9. Fig. 8: The ends of the belt
3
are fitted with holes.
Position the two ends of the belt with the belt clamp
2
exactly over the holes on the pedestal
4
and secu-
re them using screws.
10.Fig. 7: Tension belt by tightening two set screws
5
until the belt can be depressed approx 10 mm with di-
stinct counterpressure at the middle of the transport rail.
Tighten lock nuts
6
and lock screws
4
.
11.Install the two covers
2
and
9
Fig. 7
Fig. 7/8
Fig. 8
.