Operation Manual

- C 62 -
Short Seam Automat 2211-5 Working InstructionsBeisler Automated Sewing Equipment
C.5
Maintenance
C.5.5 Machine set-up
Adjustment PCB stepper motor:
The PCB for controlling the stepper motor is installed in
the control box.
NOTE - Machine cycle!
To prevent moving machine parts from colliding with
each other or with other components when the machi-
ne is switched on again, move the machine manual-
ly into its start position before the PCB is replaced.
1. Depressurize the compressed air system of the ma-
chine. Disconnect the compressed air hose of the
machine from the on-site compressed air supply
system.
2. Slide main clamp into start position.
CAUTION - Damage to electrical components!
The PCB switches must not be tampered with while
voltage is applied to the machine.
Otherwise, related electrical components may be
damaged or become unusable!
Disconnect machine from power supply system and
protect it against accidental reconnection.
Adjusting switches on the PCB:
1. Fig. 25: Set step width:
• using DIP switches 1 and 2,
• micro step at hook switches 6 and 7.
2. Set current lowering using DIP switch 3.
3. DIP-switch 4 to ON
4. Set motor phase current, rotate switch 5 to F.
5. Switch on supply voltage. When the PCB is adjusted
correctly, the LED 8 (stand-by) is illuminated, the
stand-by relay is energized.
Fig. 25
Fig. 25
DIP switch 1 DIP switch 2
200 2000 ON OFF
400 4000 ON ON
500 5000 OFF ON
1000 100000 OFF OFF
Rotary switch position Phase current DIP switch 3 Current lowering
F 5,50 A OFF ON
ON OFF
Micro step
Signal 0 = deenergized, Signal 1 = energized
Hook switch
6
open
Signal = 0
Hook switch
6
closed
Signal = 1
Hook switch
7
closed
Signal = 0
Hook switch 6 open
Signal = 1