Operation Manual

- C 63 -

Short Seam Automat 2211-5 Working Instructions Beisler Automated Sewing Equipment

C.5

Maintenance

C.5.5 Machine set-up

Setting the thread cutter:

The three-digit value input (GP Par. 35) determines when

the thread cutter is activated.

The setting of the thread cutter must be checked during

machine operation and corrected as required.

1. Rotate sewing head handwheel in direction of machine

rotation until needle reaches highest point (pinning po-

sition C).

Lock handwheel at position C by depressing pinning

pin of hole to left of handwheel.

2. Fig. 26: Install drive belt

so that the shaft feather

key

is flush with motor housing mark

3. Unlock handwheel.

4. Call menu Global Parameters:

• Press  key

• Press  GP key

Insert the following values in Global Parameters:

35: Thread lever in position up 200 INC

36: Switch-on pos. for thread cutting 110 INC

Store value and exit setting level:

• Press W key

5. Start the thread cutting function:

• Press W key

• Press  diagnostics key

• Press  sewing motor key

Fig. 26

• Press  thread cutter key

Start or stop machine run:

• Press  key

6. Check position C to see if shaft feather key

is flush

with motor housing mark

If required, change values and test thread cutting func-

tion.

7. Start thread cutting and recheck positions.