Operation Manual

Short Seam Automat 2211-5 Working Instructions
- D 82 -
Beisler Automated Sewing Equipment
D.3
Programming
6. Filling spool.
Insert thread and fill spool:
O
• Press  key.
Acknowledge status messages on display:
If the message SPOOL EMPTY is displayed, insert a full
spool and
• Press $ key.
If the message SPOOL: 004 M is displayed when a full
spool is inserted
T
• Press  key.
O
• Press  key.
NOTE - Rest thread monitor sensitivity
If the spool is empty and the display does not show
a status message, the photocell sensitivity must be
adjusted (see Section C, Service Instructions).


 Resetting the insertion process:
This function depends on the mode of machine operati-
on. It refers only to machine movements that can be per-
formed before the automatic operation.
The machine movements will be reset to start position.
• Press  key (several times if required).
!
D.3.2 Service menu start level


 Manual testing of the cutters
Sharpness and function of the three cutters can be chek-
ked individually. When the corresponding function key is
depressed, a cutting movement is performed.
1. Request the cutter test menu.
P
• Press  key.
The display shows the symbols of the selectable functions
on this level.
%%EEFGTO

2. Rear working plate cutter (left trousers component).
E
• Press  key.
3. Front working plate cutter (right trousers component).
F
• Press  key.
4. Pick-up plate cutter (left slash selvage, right side po-
cket for ladies' trousers).
G
• Press  key.
5. Pick-up plate cutter (left side pocket, right slash sel-
vage for ladies' trousers).
T
• Press  key.