Operation Manual

Short Seam Automat 2211-5 Working Instructions

- D 96 -

Beisler Automated Sewing Equipment

D.3

Programming

D.3.13 Level 2 special parameters / Lists



 Setting stitch lengths and bar tacks:

All settings for the configuration of the seam can be chan-

ged using this list.

The minimum and maximum values of input are limited

by the program control unit. Values that are not within the

limits will not be accepted but reduced to the correspon-

ding minimum or maximum value.

• Press  key.

The parameter list is shown on the display.



 Parameters for clamp transport:

This list is used to make all settings for the clamp move-

ment.

• Press  key.

The parameter list shown on the display has the following

function:

01 Clamp insertion as seen from right end of rail

02 Stop position 600 mm is a safety value. Only values

higher than 600 mm can be input

03 Settable range: 35 % - 80 %

04 Settable range: 35 % - 99 %

05 Range of the curve where no sewing is performed. If

value "0" is input here, the sewing process starts im-

mediately.



 Parameters for assistance transport:

This list is used to make all settings for the assistance

transport.

• Press  key.

The parameter list shown on the display, has the following

function:

37 Distance how long the assistance transport will trans-

port the sewing piece synchronous with the main

clamp:

00 cm = switched off

38 Synchronization from assistance transport to main

clamp:

Settable range: 75 % - 125 %