Installation Manual
9
USA
NOTICE :
• Make sure the dishwasher is plumb and notice dishwasher can be placed with a small clearance
under the counter top.
• Turning the screwdriver in the direction of the black arrows will bring the dishwasher back feet
up.
• Turning the screwdriver in the direction of the white arrows will take the dishwasher rear feet
down.
6.4 INSTALLING THE SIDE TRIM STRIPS
Remove the adhesve tape (Fgure
A
).
Place the trm strps on the front edge of the sde walls (Fgure
B
).
NOTICE :
• Make sure you use the correct trim strip since there is a left and right side strip. The flexible
material should be facing forward (Figure
B
).
6.5 PREPARING THE WATER CONNECTION (A)
Install an easly accessble shut-off valve (not suppled) n the water supply lne. All solder
connectons must be made before the water lne s connected to the dshwasher’s water nlet valve.
Water can also be suppled to the dshwasher by usng a flexble braded hose lne.
Check wth your plumbng supply sources for the proper hose and elbow and necessary fttngs for
the water supply lne. Ths materal s not suppled, and must be purchased separately.
WARNING
Installation should be performed by a qualified installer. Work by unqualified
persons could be dangerous and may void the warranty.
If the dishwasher is installed in a location that experiences freezing temperatures
(e.g. in a vacation home, cabin etc.), you must drain all the water from the
dishwasher’s interior. Water system ruptures that occur as a result of freezing are
not covered by warranty.
Water Connection