User`s guide

15
4.8.1 Redial a Number from the Redial List
1. In idle mode, press
-
to access the redial list.
Remarks: If redial entry with name, press
#
to view the number.
2. Press
+/-
to browse the redial list.
3. Press
T
or
S
to dial to the selected redial number.
Note: If there are no numbers in the redial list, the display shows EMPTY”.
4.8.2 Store a Redial Number into the Phonebook
1. Follow Steps 1 and 2 in section 4.8.1.
2. Press
M
and
+/-
to select ADD TO PB.
3. Press
M
to enter the name.
4. Press
M
to store the redial number into the phonebook.
5. Press
M
to select phonebook melody.
6. Press
+/-
to browse the melody list. The respective melody will be played
when browsing the melody list.
7. Press
M
to conrm.
4.8.3 Delete a Redial Number
1. Follow Steps 1 and 2 in section 4.8.1.
2. Press
M
and
+/-
to select DELETE.
3. Press
M
to conrm.
4.8.4 Delete the Entire Redial List
1. Follow Steps 1 and 2 in section 4.8.1.
2. Press
M
and
+/-
to select DELETE ALL.
3. Press
M
to conrm.
4. Press
M
to conrm again.
4.9 Find the Handset
You can locate the handset by pressing A on the base station. All the
handsets registered to the base will produce the paging tone and “PAGING” is
displayed on the LCD. You can stop the paging by pressing
T/O/C/S
on any handset or
A on the base again.
Note: If there is an incoming call during paging, the phone will ring with the
incoming call instead of paging.
4.10 Make an Internal Call
This feature is only applicable when there are at least two registered handsets.
It allows you to make internal calls, transfer external calls from one handset
to another handset and make conference calls. If the called handset is not
answered within 60 seconds, the called handset will stop ringing and the calling