Install Instructions

24
Tech.Doc - 03/21 - Subject to change. © Belimo Aircontrols (USA), Inc.
ZIP Economizer
Service and Commissioning
Manual Override1
Devices
Manual Override2
Forced Modes
Timeout Manual
(6)
xxhrs
Damper Pos
(4)(6)
xxx%
Compressor 1
(3)(5)(6)
On
Off
Compressor 2
(3)(5)(6)
On
Off
Exhaust Fan
(3)(5)(6)
On
Off
Fan Speed
(3)(5)(6)
High
Low
(1)
Only displayed if acceptance test or manual mode is active. If not displayed
navigation jumps over this entry. Press OK to return to automatic.
(2)
Only displayed after setup has been completed and not yet in manual mode.
(3)
Only one value below 1
st
row is displayed on 2
nd
row at any one time.
(4a)
Only displayed if Manual Override1 is active (a value is entered in Set
Timeout Manual).
(4b)
Only displayed if Manual Override2 is active (a value is entered in Set
Timeout Manual).
(5)
Only displayed if device is connected and functioning.
(6)
Press OK to change value.
(10)
Menu hidden if manual mode is active
(11)
Menu hidden and no output of alarms if manual mode is active
Damper Scaling
2
Status line “Manual Override1
Devices”
Monitor Live
Conditions
(10)
Settings Present Devices Alarm
(11)
Any key
Service and
Commissioning
(2)
Return to
Automatic
(1)
Any key
(1)
Sensor
Calibration
Return to Over
ride Settings
(4b)
Return to Over
ride Settings
(4a)
escesc esc esc esc esc esc esc
OK
OK
OK
esc
esc
esc
esc
esc
OK
esc
i
i
iii
Manual Override 1 Devices