Install Instructions

25
Tech.Doc - 03/21 - Subject to change. © Belimo Aircontrols (USA), Inc.
ZIP Economizer
Service and Commissioning
Manual Override1
Devices
Manual Override2
Forced Modes
Timeout Manual
(6)
xxhrs
(1)
Only displayed if acceptance test or manual mode is active. If not displayed
navigation jumps over this entry. Press OK to return to automatic.
(2)
Only displayed after setup has been completed and not yet in manual mode.
(3)
Only one value below 1
st
row is displayed on 2
nd
row at any one time.
(4a)
Only displayed if Manual Override1 is active (a value is entered in Set
Timeout Manual).
(4b)
Only displayed if Manual Override2 is active (a value is entered in Set
Timeout Manual).
(5)
Only displayed if device is connected and functioning.
(6)
Press OK to change value.
(10)
Menu hidden if manual mode is active
(11)
Menu hidden and no output of alarms if manual mode is active
(20)
Default Mode is forced Free cooling. If «Manual Override Forced Modes» is
quit by «Return to Automatic» the forced Mode is reset in the background to
Free cooling again. Selection DCV is only available if Energy-Stat = True AND
CO2-Stat=1 AND DCV-SetUpOk=true
(21)
Cooling stages is only displayed with selection MC (if MC is not selected,
simulated Cooling stages is reset to default Y1)
(22)
OAT simulation is only displayed with selection MC (if MC is not selected,
OAT simulation is reset to default 80°F)
(23)
SAT simulation is only displayed with selection FC, MC (if FC or MC is not
selected, SAT simulation is reset to default 70°F)
(24)
Fan Speed is only displayed with selection FC, DCV (if FC or DCV is not
selected, Fan Speed simulation is reset to default High)
(25)
CO2 simulation is only displayed with selection DCV (if DCV is not selected,
CO2 simulation is reset to default 500ppm)
Damper Scaling
2
Status line “Manual Override2
FC / IC / MC / DCV / Unoccupied”
Monitor Live
Conditions
(10)
Settings Present Devices Alarm
(11)
Any key
Service and
Commissioning
(2)
Return to
Automatic
(1)
Any key
(1)
Sensor
Calibration
Return to Over
ride Settings
(4b)
Return to Over
ride Settings
(4a)
escesc esc esc esc esc esc esc
OK
OK
OK
esc
esc
esc
esc
esc
OK
esc
i
i
i
ii
Forced Mode
Free cooling
Integrated cool
Mechanical cool
DCV
Unoccupied
(3)(4)(6)(20)
SAT simulation
xxF
(23)(6)
Fan Speed
High
Low
(3)(5)(6)(24)
CO2 simulation
xxxxppm
(3)(5)(6)(25)
Cooling stages
Y1
Y1 & Y2
(3)(6)(21)
OAT simulation
xxF
(22)(6)
OK
Manual Override 2 Forced Modes