Install Instructions

26
Tech.Doc - 03/21 - Subject to change. © Belimo Aircontrols (USA), Inc.
ZIP Economizer
Service and Commissioning
Manual Override1
Devices
Manual Override2
Forced Modes
(1)
Only displayed if acceptance test or manual mode is active. If not displayed
navigation jumps over this entry. Press OK to return to automatic.
(2)
Only displayed after setup has been completed and not yet in manual mode.
(4a)
Only displayed if Manual Override1 is active (a value is entered in Set
Timeout Manual).
(4b)
Only displayed if Manual Override2 is active (a value is entered in Set
Timeout Manual).
(5)
Only displayed if device is connected and functioning.
(6)
Press OK to change the sensor value.
(10)
Menu hidden if manual mode is active
(11)
Menu hidden and no output of alarms if manual mode is active
(12)
"Sensor 1" to be replaced by the actual sensor type. For example "SAT
Sensor" will display.
(13)
Pattern is repeated for each connected sensor.
(14)
limited to 10%rH, 100ppm CO2 and 5K for temperature
(15)
0.1-steps for the temperature sensor
(16)
1%-steps for rH humidity sensor calibration
(17)
1ppm-steps for the CO2 sensor
Damper Scaling
2
Status line
Monitor Live
Conditions
(10)
Settings Present Devices Alarm
(11)
Any key
Service and
Commissioning
(2)
Return to
Automatic
(1)
Any key
(1)
Sensor
Calibration
Return to Over
ride Settings
(4b)
Return to Over
ride Settings
(4a)
escesc esc esc esc esc esc esc
OK
OK
esc
i
i
i
i
i
"Sensor 1"
(5)(6)(12)
-VALUE-
Origin: -VALUE-
Calib: -VALUE-
OK
esc
Origin: -VALUE-
Calib: -VALUE-
OK
esc
esc
"Sensor 2"
(5)(6)(12)
-
VALUE-
Origin: -VALUE-
Calib: -VALUE-
OK
esc
OK
esc
"Sensor 3"
(5)(6)(12)(13)
-VALUE-
OK
Sensor Calibration