Install Instructions

27
Tech.Doc - 03/21 - Subject to change. © Belimo Aircontrols (USA), Inc.
ZIP Economizer
Service and Commissioning
Manual Override1
Components
Manual Override2
Forced Modes
Damper Scaling
2
Status line
Monitor Live
Conditions
(10)
Settings Present Devices Alarm
(11)
Any key
Service and
Commissioning
(2)
Return to
Automatic
(1)
Any key
(1)
Sensor
Calibration
Return to Over
ride Settings
(4b)
Return to Over
ride Settings
(4a)
escesc esc esc esc esc esc esc
OK
OK
esc
i
i
i
i
i
Damper scaling for
better operation if
obstruction is present
rescale damper in
commissioning menu.
Damper scaling
successful
maximum at
XX° = 100%
Unit starts in
XXsec
(1)
Only displayed if acceptance test or manual mode is active. If not displayed
navigation jumps over this entry. Press OK to return to automatic.
(2)
Only displayed after setup has been completed and not yet in manual mode.
(4a)
Only displayed if Manual Override1 is active (a value is entered in Set
Timeout Manual).
(4b)
Only displayed if Manual Override2 is active (a value is entered in Set
Timeout Manual).
(5)
Only displayed if device is connected and functioning.
(6)
Press OK to change value.
(10)
Menu hidden if manual mode is active
(11)
Menu hidden and no output of alarms if manual mode is active
Damper Scaling