Use and Care Manual

5. To assemble for grinding or whipping,

using the blade’s collar to handle,

place the grinding (at) blade into the small

grinding cup.

IMPORTANT: Check to make sure the cup

ring is not attached to the blending cup before

assembling the blade. If it is, simply lift off

to remove.

IMPORTANT: In the base of each blade’s collar,

there is a plastic gasket seal that creates

an airtight t with the Rocket processing cups.

After dishwashing and before each use,

always check to make sure the gasket

is properly in place, as the heat from some

dishwashers may cause the gasket

to become loose.

WARNING: Never operate the Rocket Blender

when the processing cup is empty.

WARNING: Never overll the processing cup. Do not exceed the MAX line.

6. Hold the cup (tall or small) rmly in one hand. Use the other hand to tighten

the cup/blade assembly by turning the blade collar clockwise until snug.

7. Plug the power cord into a 120V AC electrical outlet.

8. Invert the processing cup/blade assembly. Insert the blade collar into the motor base,

tting the tabs into the slots on the motor base.

NOTE: The Rocket Blender will not operate unless the 3 locking tabs on the blade collar

are properly tted into the 3 slots on the motor base.

SO-307632 12 pc Chrome Rocket Blender_r4.indd 5 2013-07-19 10:56 AM