Installation Guide

Header – B1 = B+44 (B+1 3/4”)
4. CUTTING HEADER TO THE SIZE OF THE DOOR
Jumb - H1=H+(27-47) (Н+(1 1/16"-1 7/8")
Drill holes with a diameter of 5/64x6/64".
Tighten with 1/4x2" screws.
5. ASSEMBLING THE SINGLE SWING DOOR KNOCK DOWN SET
6. ASSEMBLING THE SINGLE SWING DOOR KNOCK DOWN SET
7. HANGING THE PRE-CUT DOOR SLAB
Insert all hinges into the frame, insert
all hinges into the slab
If necessary adjust the Hinges with the
use of an allen key (not provided)
Door frame should be put into the opening.
It is fixated with wooden wedges.
Be sure to use pair wedges, setting them
opposite to each other. The upper wedges
should be at the interface levels of the vertical
and horizontal parts of the door frame.
In order to fixate the bottom of the door frame
with wedges, align the hinge side, check
with building level in two planes.
Use 2 ½” screws (not provided) to secure the hinge