Warranty Guide

Belldinni Inc.,
www.belldinni.com
970 New Brunswick Ave.,
Rahway, NJ, 07065
Belldinni’s responsibility for the merchandise is limited to the regulations of the present
Manufacturer’s Warranty.
All Belldinni doors are manufactured to the highest-quality craftsmanship standards and are backed by a limited 2 year
warranty against defects in workmanship and materials. The 2 year period starts from the date of delivery of goods to
the customer.
WHAT THIS LIMITED WARRANTY DOES NOT COVER
This Limited Warranty does not include non-conformities or damages attributable to or arising from:
• General wear and tear.
• Any Product that is over three-feet (3′) in width and/or eight-feet (8′) in height.
• The finish on a locking system (door handles and lockset) and hinges is not warranted and is purchased “AS
IS”. This includes but is not limited to finish discoloration, tarnishing, scratches, abrasions, and visual
imperfections. Exposure to certain environmental conditions, including but not limited to salt spray, acid rain,
high humidity, or other corrosive elements may adversely affect the coatings on finishes (as well as the
mechanical and multi-point locking system (door handles and lockset mechanisms). Timely and proper
cleaning of hinges and a multi-point locking system will help to extend the finish appearance (and mechanical
mechanisms) and discourage the possibility of rust and corrosion. Hinges and a locking system (door handles
and lockset) should be wiped down periodically with a soft, water-dampened cloth and dried off with a soft
dry cloth. Abrasive cleaners or other harsh chemicals should never be used on hinges or a locking system
(door handles and lockset). Maintenance of the finish (and mechanical mechanisms) is the responsibility of the
Warranty Holder.
• The mechanism on hinges installed within 5 miles of a body of salt water.
• The mechanism on the locking system if the Product is installed within 5 miles of a body of salt water or
installed on any steel products. Belldinni does not recommend the use of locking systems with steel products.
If any locking system is used with steel products, it’s used “AS IS” WITH NO WARRANTIES.
• EXPRESS OR IMPLIED WARRANTIES, INCLUDING ANY RELEVANT TO ITS SUITABLITY FOR
ANY PARTICULAR PURPOSE OR USE.
• Failure by the Warranty Holder or its agents to observe one or more of the following rules of Product handling
will void this Warranty:
- Avoid direct contact with water, fire, sunlight exposure;
- Avoid rough handling of doors and door units;
- All doors must be transported in containers, on pallets or other devices, protecting them from damage,
moisture, precipitation or sunlight exposure;
- The door assembly in newly built or repaired premises is allowed only after the building materials have dried
out completely;
- Prior to the installation, doors and door units must be kept at the place of installation 3-4 days before they
achieve optimum humidity and temperature parameters;
- Door unit installation should be carried out by trained and properly qualified specialists;
- Prefinished door units should be installed after the floor, ceiling and wall priming and painting is over, in
order
to secure the door finishes from getting stained and/or dirty;
- Only detergents (not water!) suitable for corresponding surfaces (veneer, enamel, polypropylene) and
containing no abrasives and solvents can be used for cleaning a door unit;
- Aerosols for wooden furniture may be applied on a door unit to give the surface additional shine and
freshness (with reference to the recommendations on the use of aerosols);
- It is forbidden to knock on the door glass with objects that may cause the glass shattering;
• Misapplication of Products or faulty building design or construction, including inadequate flashings, caulking,
building settlement, or structural failures of walls or foundations, or inadequate overhangs;