Instructions / Assembly

ManualsBrandsBelldinni ManualsBarn DoorsAvanti 207 36 in. x 92-1/2 in. Full Lite Frosted Glass Black Apricot Wood Composite Sliding Barn Door with Hardware Kit

Product Installation

Instructions Guide

Please read this installation guide carefully before installation.

Please refer to the relevant content of this store for more product use.

OPERATION CAUTIONS:

Email: smartstandard@aliyun.com

Barn door hardware

Website: smartstandard.com

Summary of content (6 pages)

PAGE 1
TM Product Installation Instructions Guide Barn door hardware OPERATION CAUTIONS: Please read this installation guide carefully before installation. Please refer to the relevant content of this store for more product use. Website: smartstandard.com Email: smartstandard@aliyun.
PAGE 2
Pencil Phillips Screwdriver Wrench Tape Plumb Bob Level Drill Drill Bit Hanger Rail Door Stopper 1 Lag Bolt & Anchor Rubber End Wall Spacer Floor Guide Hex Key 2
PAGE 3
A 16” 16” 16” 16” Connect two rails together (If the rail is one piece please skip this step). 1.2 Place the rail against the wall, and use a pencil to mark where the holes should be. Make sure the height of holes on the wall is H+1/”. A The gap between each pre-drilled B 1/” D H 1.1 E H+1/” hole is 16”. B Distance from door top side to holes on the wall is 1/”. C Distance from the bottom of the door to the floor is /”. D Door height is H.
PAGE 4
A B C D Insert door stoppers into rail. Install door stoppers between A-B and C-D. Door stopper is used to prevent the hangers coming out of the rail. Do not screw it in place at this stage /” The rubber ends are used to protect the door from touching the rail when sliding the door. You need to drill holes on the door top side, please drill the holes ½” away from the edge of the door. Then install the rubber ends on the door. * This manual is in general use.
PAGE 5
Adjust the 2 door stoppers to find a suitable position, Use the hex key to screw the door stoppers in place. ’’ 1/ ’’ 3/ 2’’ ’’ 3/ ’’ 1/ ’’ 3/ ’’ 1/ ’’ 3/ ’’ 1/ ’’   2/ ’’ 1/ 4/’’ Install the floor guide. Put floor guide on the floor first to fix a suitable position and make a mark so that the tip of the floor guide can work well in the slot.
PAGE 6
/ / /