Owner's Manual

move forward in the list.“MSG 1” will appear in the display
confirming your selection (to move backward in the list,press
the drk button).Pressing the aud button allows you to view
the sws
™
message in the display.Press the cty button again to
step to the next message; press the aud button to review,and
so on.This allows you to review all 60 messages.
To exit Tutorial Mode, press the pwr button and your unit
will be on and ready to receive signals.
Set and Forget Memory
Any time vector lr is turned off or unplugged from the
cigarette lighter socket,all feature settings you have selected are
retained in the unit’s memory.Set and Forget Memory
eliminates the need to reset your preferred feature settings
each time your unit is turned off and then back on.
Reset to Factory Settings
You can reset your unit to factory settings for Start-Up Mode,
volume, drk,aud, cty and Selectable Features.To reset, press
and hold the cty button until the display shows “
RESET”.
Two “beeps”will sound and your unit will cycle through the
NORMAL Start-Up mode and be on and ready for operation.
drk (Bright/Dim/Dark) Button
The drk button allows selection of a bright,fully adjustable
dim mode or dark mode.The unit is factory preset to full
bright display.To engage dim mode,press and hold the drk
button.The display will cycle through various levels of dim
illumination.Release the button at your chosen level.To
engage dark mode,press the drk button a second time.A
single “beep”coupled with the brief illumination of“
DARK”
on the display confirms your selection.You’ll notice an “H”
(Highway mode) or “C”(City mode) remains dim to confirm
your unit is receiving power.To return to a full bright setting,
press the drk button a third time;two “beeps”confirm this
selection.Use of the drkbutton does not affect audio alerts.
Important—if you press the the drk button and do not receive
audible confirmation,the audio level has been set too low.
