Owner`s manual

Page 3
Assembly Instructions
1. Attach the Euro hinges to the door as shown.
Press the hinge cups into their bores. Turn the integral hinge
cams to tighten.
2. Attach the hinge mounting plates to the left side cabinet
panel.
Note the orientation in the photo. The hinge resembles the letter
"t". Locate the top of the "t" nearest the front edge of the side
panel as shown in the photo. Make sure the spring loaded
release lever faces the back edge of the cabinet.
3. Attach the plastic door stop to the right side cabinet panel.
Use the small #7 x 3/4" silver colored wood screw.
Door stop detail
1/4-20"
cross dowel
Panel
Panel
Cross Dowel
Bolt
4. Attach left and right side panels to the back panel.
Do not install the panels upside down. Position the cord cut-out
to the bottom right. Use the 1/4-20 x 2" round head bolts and
cross dowels, and the supplied 4mm wrench to tighten the bolts.
The cross dowels may fit tightly into their holes. Tap them in with
a hammer if necessary. The drawing below shows how these
strong but simple fasteners fit together.
Right Side (top)
(cabinet inside)
plastic door
stop hole
Door
cup holes for hinges
door handle holes
(cabinet inside)
Left Side (top)
holes for hinge
mounting plates
cross dowel holes
(cabinet inside)
1/4-20 x 2"
round head bolt
1
2
Top of "T"
mounting
plate.
4
Front Edge
of Cabinet
Front edge
of cabinet
3
Spring loaded
release lever