User Manual
SmarTire
™
TPMS Compatibility Chart Notes
*SW: 4.26, 3.17 Limited release; for specic customer applications only; contact Bendix CVS for availability.
REV 1.3 **SW: 2.1
Gauges with SW Version 2.1 or older should be upgraded to Version 2.2 part # 248.0087; contact Bendix
CVS for upgrade instructions; does not apply to Version 3.0 or higher.
Note 1:
Some Features not compatible
J1939 Receiver Version 1-3 does not have features such as trailer monitoring and multi-tire autolearn.
Software upgrade on receiver is required to access these additional features.
Note 2:
CAN communication limitation;
some features not supported
1. This version of receiver is able to send RTS/CTS and BAM sessions simultaneously but the gauge
does not support this. This will cause the gauge to initialize improperly.
2. This version of receiver has features such as trailer monitoring and multi-tire autolearn which this
version of the gauge does not support. Software upgrade is required to access these additional features.
Note 3:
DTC format change
Because the DM1 version is not recommended by the SAE standard, it is recommended to upgrade
receiver to R1-3, which uses latest DTC format and includes additional enhancements.
SmarTire
™
Tire Pressure Monitoring System (TPMS) Software Compatibility Chart
For all congurations below, always upgrade to the highest software/hardware revision for the gauge/receiver combination.
Revision and software information can be read on the gauge during start-up.
If you have:
Rev 1.2
SW: 1.6
Rev 1.3
**SW: 2.1
Rev 1.4
SW: 3.0
Rev 2.0
SW: 4.1
Receiver Model
200-0184
(See white label on
housing for model
number)
Rev X-X
*Software (SW):
4.26, 3.17
>>
Software
Can Be
Upgraded
Where
shown
No
>>
Software
Can Be
Upgraded
From 1.6 to
2.1
No
A Hardware
Change was
Implemented:
Software
cannot be
Upgraded from
2.1 to 3.0
<|>
A Hardware
Upgrade is
Required for
Additional
Features
Yes
(See Note 2)
>>
Software
Can Be
Upgraded
From 3.0 to
4.1
Yes
Rev 1-3
SW: 3.13, 2.2
No Yes Yes
Yes
(See Note 1)
Rev 1-2
SW: 3.11, 2.17
Yes
Yes
(See Note 3)
Yes
(See Note 3)
No
Rev 1-1
SW: 3.09, 2.15
No No No No
Rev 1-0
SW: 3.08, 2.15
No No No No
Receiver Model
200-0180
(See white label on
housing for model
number)
Rev 1-2
SW: 1.18, 1.5
No No No No
Rev 1-1
SW: 1.15,1.5
No No No No
Rev 1-0
SW: 2.18, 2.09
No No No No
Note: Legacy Receiver Model 200-0153 is not compatible with any of the above.
Gauge
Version
200-0179
BW2825
©2010 Bendix Commercial Vehicle Systems LLC,
a member of the Knorr-Bremse Group
7/10 • All Rights Reserved
For more information call: 1-800-AIR-BRAKE
1-800-247-2725 • www.bendix.com