User Manual

OBSTRUCTION / CHOKE TUBES

CONDITION CHECK

Check the barrel to ensure there are no obstructions in the chamber and bore.

This is extremely important because serious injury can result to the user or to

nearby persons if a cartridge is ﬁred in an obstructed barrel or chamber.

Check the inside of the barrel prior to completely assembling the ﬁrearm and

before use; if the ﬁrearm is already assembled the following procedure should

be followed:

• Followtheinstructionsinthe“Disassembly”sectionand removethebarrel

from the shotgun.

• Afterremovingthebarrel,lookrightthroughthebarrelfromtherearandmake

sure there are no obstructions, even minor ones.

• Ifanobstructioninthebarrelisdetected,acompetentgunsmithmustremove

the obstruction. Inspect again the shotgun before it can be ﬁred.

• Remountthe barrel, following the instructions set out in the “Reassembly”

section.