User Manual
25
EN
REASSEMBLY
WARNING: Always check that the shotgun is unloaded (empty cartridge
chamber, empty receiver, empty magazine). Inspect the firearm by looking
through the ejection port, the loading gate and the chamber. If it is not empty,
unload it as instructed in the relevant section.
WARNING: Never point the firearm at someone or at hard, flat surfaces. Always
treat the shotgun as if it were loaded. (See points 1, 2 and 4 of the BASIC
SAFETY RULES).
TRIGGER PLATE
• Workinreverseordertoassembly,takingcaretoensurethatthehammeris
cocked (Fig. 20), the safety is engaged and the carrier stop push button is
pressed down.
• Keeping the release button pressed well down, make the rear part of the
trigger plate adhere precisely to the receiver and push firmly towards the
stock, as far as it will go.
• Rotatethetriggerplateuntilitisinsertedinitshousinginthereceiver.
• Insertthetriggerguardretainingpinonlywhentheholeofthetriggerguardis
centred on the receiver.
BREECH BOLT ASSEMBLY
(Breech bolt, operating rods with sleeve, recoil spring, and piston stop).
• Workingonaatsurfacewiththeejectionportturnedup,mountthebreech
bolt assembly, operating rods with sleeve, recoil spring and piston stop on
the magazine tube (Fig. 15).
• Pushtheoperatingrodswithsleeveallthewayintoinsertthebreechboltinto
the receiver.
• Presstheheadofthebreechboltuntilthegrooveonitsneckcorrespondsto
the edge of the bolt body.
• Keepingtheheadpresseddowninthisposition,insertthecockinghandleon
the breech bolt. Fasten it into position by hitting it firmly (Fig. 14).
BARREL
• Checkthebarrel.Thebarrelandcartridgechambermustbecleanandfree
from obstructions.
• Insertthepistonintothegascylinderofthebarrel,tighteningtheelasticseal
with the fingers to make it easier to install the piston in the cylinder (Fig. 21
and 22).