User Manual

26
EN
• Checkthatthecarrierstoppushbuttonispressedallthewaydown.Ifitis
not, push it all the way down (Fig. 1).
• Pullthebreechboltallthewaybacksothatitremainsopen(Fig. 2).
CAUTION: When the release button is pressed, the breech bolt is pushed
forward by the recoil spring, until it is stopped at the ejection port by the cocking
handle, with the likelihood of damage to both parts.
• Insertthebarrelintothereceiver,ensuringthatthemagazinetubeentersthe
piston hole as well as that of the gas cylinder and the valve assembly (Fig.
23).
• Pushitallthewayintothereceiveruntilitstops.
• Slidethefore-endintoplaceoverthegascylinder/thevalveassemblyand
magazine tube (Fig. 10). checking for the correct centering on the receiver
face. The fore-end is in the correct position when it is fully against the receiver.
• Screwthefore-endcapthemagazinetubeextensionontightly(Fig. 9).
• Keepyourngersawayfromtheejectionport,pressthebreechboltrelease
button and gently guide the breech bolt to lock.
• Keepingthebreechboltpulledback2cm,pullthetrigger,therebydecocking
the hammer.
WARNING: Store your firearm so that children or other persons not familiar
with firearms cannot gain access to it. To reduce the risk of accidents involving
children, unload your firearm and lock it away. Store the ammunition in a
separate locked location. (See point 3 of the BASIC SAFETY RULES).
NOTICE: If the firearm will not be used for a long time, keep it lubricated and
disassembled(seethechapters“Maintenance”and“Storage”).