User Manual

FIELD STRIPPING

• UsethePhillipsscrewdrivertoremovethetwoscrewssunkintothestock.

• RemovetheBerettaMicrocorerecoilpadfromthestock.

• Usethe13-mmtubewrenchtocompletelyunscrewtheretainingnutofthe

stock and remove the nut, spring washer and plate .

• Separatethestockfromthereceiverandremovetheplate.

REASSEMBLY

• Centrethefrontspacer on the stock bolt tube. Make sure that the indicator

showingthedesireddropandcast(“C-60-DX”inthediagram)isvisibleon

the spacer.

• Repositionthestock.Placetherearplate inside the stock. Make sure that

the same marking is visible on the plates.

• Usethe13-mmtubewrenchtoinserttheretainingnutofthestockandspring

washer and tighten down with tightening torque 1.6 - 1.8 Kgm (Kilogram-

meters). The use of a proper dynamometric wrench is recommended.