Instruction manual

158
Cleaning
Cleaning
Cleaning the Display and the sewing computer
Wipe with a soft, damp cloth.
Feed dog area
Clean the sewing computer after every use - remove any lint from under the
stitch plate and in the hook area.
⦁
turn power switch to «0» (off)
⦁
remove plug from electrical outlet
⦁
remove presser foot and needle
⦁
open the bobbin door
⦁
press the stitch plate down at the right back corner until it flips up
⦁
remove the stitch plate
⦁
clean the area with the lint brush
⦁
replace the stitch plate
Lubricating
⦁
turn power switch to «0» (off)
⦁
remove plug from electrical outlet
⦁
squeeze 1 or 2 drops of BERNINA oil into the hook race
⦁
turn power switch to «I» (on)
⦁
run the sewing computer for a short time (without thread)
►
so sewing project is not soiled
ATTENTION!
Disconnect plug from the socket before cleaning or lubricating!
Never use alcohol, petrol, white spirit or any type of solvent to
clean the sewing computer!
Cleaning the hook
⦁
turn power switch to «0» (off)
⦁
remove plug from electrical outlet
⦁
remove bobbin case
⦁
clean the hook race with a lint brush, do not use sharp instruments for
cleaning
⦁
insert the bobbin case
034790.50.04 _2013-03_Manual_B560_EN