Instruction manual

163
Troubleshooting
̶ BERNINA USB stick is not inserted
̶ New SW Version is not available on
the stick
⦁
insert BERNINA USB stick and do not remove during the
update process
⦁
save the new SW Version on the BERNINA USB stick and
start the update again
̶ Update successful
̶ The sewing computer must be
cleaned/lubricated
̶ It is time for the regular maintenance.
Please contact your BERNINA dealer
or your BERNINA service address
⦁
the sewing-/embroidery computer has been provided with the
latest software version
⦁
this notification will appear after approx. 180,000 stitches.
After cleaning/oiling clear the Display by touching . The
Display can be cleared temporarily by touching , but will
appear again when restarting the sewing computer. After
clearing with «ESC» for the third time, the cleaning
notification will only appear again after a further approx.
180,000 stitches
⦁
the sewing computer must be taken to an authorised
BERNINA dealer/servicing shop. The message appears after
approx. 2,000,000 stitches. Once the servicing has been
performed by an authorised BERNINA dealer/ servicing shop,
the stitch counter is reset to «0» (zero) and
the message disappears.
The message can be deleted temporarily by touching the field
«ESC» but will reappear when the sewing computer is next
restarted. After the third deletion with
the message will not
reappear until the next reminder at approx. 4,000,000 stitches
(in total).
Having your sewing computer cleaned and serviced properly
at the appropriate times ensures its proper functioning and
long service life. Failure to do so may adversely affect service
life and limit the guarantee. The charge for servicing is
nationally regulated – consult your dealer or servicing shop
for details
General Repair Messages
Explanation
034790.50.04 _2013-03_Manual_B560_EN