Instruction manual

20
Sewing preparation
2
1
5
4
3
⦁
turn power switch to «I» (on)
⦁
place empty bobbin on spindle
Then proceed as mentioned above.
⦁
push engaging lever 2 against bobbin
►
the winder works automatically
►
the Display to wind the bobbin is opened
⦁
move the round knob in the Display to the left/right or
⦁
turn the stitch width knob (see page 12)
►
the winding speed is altered
►
the motor will stop automatically when the bobbin is full
►
the Display is closed
⦁
remove bobbin and
⦁
pull the thread over thread cutter 3 to cut it
Winding a bobbin
Bobbin winding while sewing
⦁
attach foam pad on the vertical spool pin 4
⦁
place thread on the vertical spool pin
⦁
following the direction of the arrow, take the thread through the thread
guide 5 and
⦁
guide around the pre-tension stud
⦁
place foam pad on the spool pin
⦁
place thread on the spool pin
⦁
attach appropriate spool disc
⦁
following the direction of the arrow, take the thread through the rear guide
and round the pre-tension stud
⦁
wind the thread two to three times around the empty bobbin
⦁
cut off any excess thread on the thread cutter 1
Appropriate spool disc
Diameter of thread spool determines disc size. There must be no
gap between the disc and the spool.
It is recommended to reduce the winding speed when winding from
the vertical spool pin.
034790.50.04 _2013-03_Manual_B560_EN