Installation Sheet

> Access the back of the appliances to mount the

joining brackets: ﬁx one side of the top and lower

brackets to one of the appliances and subsequently

to the other [ 2 ].

> Next join them at the front attaching the plastic

connecting brackets with the supplied screws [ 3 ] .

Attach the bracket on top of the units (if applicable)

as per ﬁgure [ 4 ].

> Finish o by mounting the central proﬁle cover

onto the central proﬁles, by pushing it until a click

is heard [ 5 ].

> Once completed, push the units into their ﬁnal po-

sition [ 6 ].

If the units are to be installed inside a cutout or

within an enclosed structure, it is necessary to ac-

commodate air ﬂow at the back of the cutout to

assure proper ventilation at the back of the unit of

about 5mm. Always mount front panels on door and

drawer before pushing the unit into its ﬁnal position

inside the cutout or structure.

> Check the levelling of the appliance, adjusting its

feet and wheels to correct it.

> Secure the appliance to the adjacent cabinets by

ﬁxing to these the side proﬁles trims factory-in-

stalled on the appliance [ 7 ]. To make this operation

easier keep the door open.

> Mount the covering frames onto the proﬁles, ﬁrst

insert them laterally and then push ﬁrmly until a

“click” is heard [ 8 ].

Take care as appliances will be front-

heavy and may tip before they are se-

cured to the adjacent furniture.