REARWARD-FACING USER MANUAL ECE R44 04 GROUP WEIGHT AGE 0+/1 0-18 kg 6m-4y 1
Thank you for choosing BeSafe iZi Kid ISOfix. BeSafe has developed this seat with much care, to protect your child during the next phase of her or his life. It is important that you read this user manual BEFORE installing your seat. Incorrect installation could endanger your child.
Preparing to install Crucial parts Rearward-facing: ISOfix installation Release handle head rest Adjustable head rest Harness shoulder straps Harness buckle Central adjuster Front brace Reclining lever Belt guiding hook Ratchet for front brace Switch for ISOfix connectors (2x) Locking bolt floor support Belt loop floor support Floor support ISOfix car anchorage (2x) ISOfix connectors (2x) ISOfix insertion clips (2x) ISOfix release button (2x) Cap ISOfix connector (2x) 4 • It is NOT ALLOWED to mount the
5- Install the front brace by sliding the two pins in the holes of the belt guiding hook. Move the front brace inwards with the ratchet, not further than the stop sign. The ratchet is used to adjust the front brace in both directions. Slide the knobs (see red circle) on the ratchet up or down to change direction (4). 9- Place the seat sideways into the car with the front brace towards you. 10- Turn the seat into the right position (with the front brace against the back rest).
15- Move the front brace outwards with the ratchet. Continue tightening until the brace is pressed well into the back rest of the vehicle seat (10). (10) • Make sure the floor support is fully pushed down, in contact with the floor of the vehicle, and locked. • Make sure all ISOfix indicators are green before you drive. ! Removing the seat 1- If the seat is installed in the back seat of the vehicle, push the front seat of the vehicle forward as much as possible.
Positioning of the child 1- Position of the shoulder straps: Check that the shoulder strap slots are levelled with your child’s shoulders (15). too high (15) 3- Pull the shoulder straps up while pressing the button of the central adjuster (17). (18) too low correct 2- The height of the shoulder straps and the head rest can be adjusted by releasing the release handle at the back of the head rest and pulling the head rest up or down while keeping the head rest upright (16).
Removing and refitting the cover • There are 2 versions of the fabric cover. If there are velcro squares (see green arrow (22/23)), follow the steps of alternative 1. If there are no velcro squares go to alternative 2. (22) (23) Removing the cover: alternative 1 1- Pay attention when you remove the cover, as fitting the cover is done in the opposite way. (24) 2- Start to take off the lower seat part (24).
Cleaning instructions Important advice • The cover of the seat must be washed according to the instructions on the inside of the cover (26). • DO NOT attempt to dismantle, modify or add any part to the seat. Warranty will expire if non-original parts or accessories are used. • DO NOT use anything, such as a cushion, to raise the child seat off the passenger seat of the vehicle. In an accident the seat will not be able to protect your child in the right way.
16 Guarantee Point of sale information • All BeSafe products are carefully designed, manufactured and tested. All of our BeSafe child seats are tested periodically out of our continuous production in our test laboratory. Furthermore they are tested by independent test institutes. • Should this product prove faulty within 24 months of purchase due to materials or manufacturing fault, except covers and harness straps, please return it to the original place of purchase.
B905-8020-B N2001060 semi-universal 0-18 kg R 44 04200 HTS BeSafe as N-3535 Krøderen, Norway - www.besafe.